文档介绍：摘要
本设计为落料拉深复合模及典型工作零件的工艺分析。全文将设计思路作为一条主线贯穿始终,所采用的设计思路为:取得必要的资料对冲裁零件进行多方面的认识、分析,其中最重要的是对其进行工艺方面的分析。作好以上的工作后,设计进入了最为核心、最为重要的一步,即进行必要的工艺计算和确定模具主要工作零件的结构型式、相关尺寸。有了整个设计的核心灵魂后,然后对模具的其它组成零件完成设计,从而完善整个模具。综合上述的分析、计算、总体设计后,选好冲压设备,画好模具总装配图和各非标准零件图。整个设计思路是成一条脉络展现的。
关键词: 冲孔;落料;复合模;工艺分析;模具;拉深
ABSTRACT
Compound die Blanking Drawing is an efficient and precise provision of normal stamp die. For the part can not finished in only one stamp working procedure,it is better machining on pound die according to the technical demands of the part. In the thesis, designed pound mold used to machining the half-finished clutch shell. This set of mold suits in the clutch shell punch central hole, stamp bottom convex shape, and shave fringe, after that still had several processing working procedures. When carries on the design of pound mold, the main question is to confirm the way of stamp the bottom convex figuration. Because it is have to guarantee the fore working procedure’s approximate shape precise, uses partial-undulate stamp in here to processing the bottom bulge. Therefore, the key role to eed of the partial-undulate stamp is to define reasonable blank holding force. At the same time, when stamped conical convex bulge, the design of convex-concave die is also important. In order to the standardized design, has selected the standard part as far as possible. Such as die frame, die bed plates, press machine and so on. Finally, set down the machining technical procedure of sleeve, a major ponent. The design in the thesis has some referenced value for analogical calendaring molding design.
Keywords: mold design; compound die; calendaring molding;Drawing
目录
1 前言 1
2 原始数据图 1
3 冲压工件的工艺性分析 2
4 分析确定工艺方案及模具型式 3
5 主要工艺参数计算 4
毛坯尺寸的计算 4
排样方式的确定及其计算 4
材料利用率 5
成型次数的确定 5
计算冲压力 5
定模具压力中心 7
工作部分尺寸的计算 7
6 模具整体设计及模具总装图 9
7 模具主要零部件结构设计 11
11
13
13
14
紧固件的设计 14
模柄及凹模固定板得设计 15