文档介绍：毕业设计(论文)任务书
题目
单片机串行通信发射部分设计
学生姓名
解小斌
院系、专业班级
电子工程学院电子0101
内容
与
要求
学习单片机及串行通信的有关知识;
设计单片机串行通信发射部分电路;
制作并调试电路;
编制软件并调试之;
写出毕业设计论文;
翻译10000字符的英文资料。
设计(论文)时间
2005年 3月1日至2005年 6月10日
教研室(系)审查意见
学生签名
指导教师签名
2005年 3月 09日
单片机串行通信发射部分设计
摘要:我所做的是单片机串行通信发射机,它能显示数字信号,还能将信号发射出去。采用串行工作方式,能显示00-99的数字,用单片机89C51来控制,采用共阳极数码显示,软件部分由汇编语言编写。
单片机串行通信发射机是用来发射信息,能完成信息准确无误的显示发射,使信息能够在两地之间传递,给人们在通信上带来方便。发射机设计的思路是:由一片单片机来控制信息的发射、存储和显示,用汇编语言编写发射程序和显示程序,使硬件和软件加以结合,完成发射机的设计。
硬件的设计要考虑多方面,以自己设计的目的为出发点,设计合理的方案。发射机需要硬件和软件的配合、补充,软件编写要和接收机达成相同的通信协议,这样才能完成预期的效果。
关键词:单片机,汇编语言,数字信号,发射
The Design of Micro Controller munication Transmission
Depart
Abstract: What I do is a Micro Controller Unit correspondence blast-off device, it can show the digital signal, and also can send out the signal .It uses serial-port operating mode, can show the number from 00 to 99, control with a machine 89 C51s, adopt the total anode figures manifestation, the software part from edit collected materials the language plait to write.
A Micro Controller Unit correspondence blast-off device is used for sending out the information, it plete the information accurate without any error of manifestation blast-off to make information delivered between the two sides and bring the convenience on the correspondence to the way of thinking that blast-off device design is controlled the blast-off of information by a machine of one, saving and manifestation, use to edit collected materials the language plait to write to shoot the procedure and the manifestation procedures, make hardware and softwares take bine, complete the design of blast-off device.
The design of the hardware need to consider in many ways,taking the purpose that oneself design as the point of departure to design the reasonable blast-off device need moderate between hardware and software edition want to reach with receiver correspondence protocol of the machine demand hardware, then plete the anticipant