文档介绍：E351 MANUAL TRANSAXLE – MANUAL TRANSAXLE SYSTEM MX–1
MANUAL TRANSAXLE SYSTEM
PROBLEM SYMPTOMS TABLE
Use the table below to help you find the cause of the problem.
The numbers indicate the ranked order of probability of each
of the possible causes. Check each part in order. Replace
parts as necessary.
Manual transaxle system (MTM)
Symptom Suspected area See page
1. Oil (Level low) MX-2 MX
2. Oil (Wrong) MX-2
3. Gear (Worn or damaged) MX-54
- MX-79
Noise
- MX-89
4. Bearing (Worn or damaged) MX-40
- MX-79
- MX-89
1. Oil (Level too high) MX-2
2. Gasket (Damaged) MX-40
Oil leakage 3. Oil seal (Worn or damaged) MX-5
- MX-99
4. O-Ring (Worn or damaged) MX-40
1. Control cable assembly MX-13
2. Synchronizer ring (Worn or damaged) MX-54
- MX-79
Hard to shift or will not shift - MX-89
3. Shift key spring (Damaged) MX-40
- MX-77
- MX-87
1. Locking ball spring (Damaged) MX-40
2. Shift fork (Worn) MX-54
- MX-79
- MX-89
3. Gear (Worn or damaged) MX-54
Jumps out of gear
- MX-79
- MX-89
4. Bearing (Worn or damaged) MX-40
- MX-79
- MX-89
MX–2 E351 MANUAL TRANSAXLE – MANUAL TRANSAXLE OIL
MANUAL TRANSAXLE OIL
ON-VEHICLE INSPECTION
1. INSPECT MANUAL TRANSAXLE OIL
(a) Stop the vehicle on a level surface.
(b) Remove the transmission filler plug and gasket.
0 to 5 mm (c) Check that the oil surface is within 5 mm ( in.) of
(0 to in.) the bottom of the transmission filler plug opening.
D025304E01 NOTICE:
MX • Excessively large or small amounts of oil may
cause trouble.
• After replacing the oil, drive the vehicle and
check the oil level again.
HINT:
Insert your finger into the filler plug hole. You should
be able to just touch the surface of the oil if the oil is
at the correct level.
(d) Check for oil leakage if the oil level is low.
(e) Install the transmission filler plug and a new gasket.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
E351 MANUAL TRANSAXLE – DIF