文档介绍：AXLE – AXLE SYSTEM AH–1
AXLE SYSTEM
PROBLEM SYMPTOMS TABLE
Use the table below to help find the cause of the problem.
Check each part. If necessary, replace these parts.
Symptom Suspected area See page
1. Wheel alignment (Front) SP-4
2. Wheel alignment (Rear) SP-13
3. Steering linkage PS-49
Wander 4. Hub bearing (Front) AH-5
5. Hub bearing (Rear) AH-14
6. Stabilizer bar (Front) SP-33 AH
7. Stabilizer bar (Rear) SP-69
1. Shock absorber SP-18
Front wheel shimmy 2. Lower ball joint SP-28
3. Hub bearing AH-5
AH–2 AXLE – FRONT AXLE HUB BOLT
FRONTSUSPENSIONAXLE & AXLE AXLE HUB BOLT
COMPONENTS
107 (1,090, 79)
AH
FRONT DISC
FRONT AXLE HUB BOLT
FRONT DISC BRAKE CALIPER ASSEMBLY
N*m (kgf*cm, ft.*lbf) : Specified torque Non-reusable part
C137195E01
AXLE – FRONT AXLE HUB BOLT AH–3
REPLACEMENT
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER
ASSEMBLY (See page AH-6)
3. REMOVE FRONT DISC (See page BR-49)
4. REMOVE FRONT AXLE HUB BOLT
(a) Temporarily install the 2 nuts and washers to the
SST front axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to
hold the front axle, remove the front axle hub bolt.
SST 09628-10011
AH
SST
Hold Turn
C112993E02
5. INSTALL FRONT AXLE HUB BOLT
Nut (a) Install a washer and nut to a new front axle hub bolt
as shown in the illustration.
(b) Using a brass bar to hold the front axle, install the
hub bolt by torquing the nut.
6. INSTALL FRONT DISC (See page BR-51)
Washer
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
Turn
Hold (See page AH-10)
C108165E02 8. INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
AH–4 AXLE – FRONT AXLE HUB
FRONTSUSPENSIONAXLE & AXLE AXLE HUB
COMPONENTS
FRONT SHOCK
ABSORBER ASSEMBLY
19 (192, 14)
AH 210 (2,140, 155)
FRONT SPEED SENSOR (82, 71 in.*lbf)
FRONT DRIVE
SHAFT ASSEMBLY
TIE ROD END SUB-ASSEMBLY
107 (1,090, 79)
FRONT AXLE