文档介绍：METER – METER / GAUGE SYSTEM ME–1
METER / GAUGE SYSTEM
Negative (-)
Terminal PRECAUTION
1. REMOVAL AND INSTALLATION OF THE BATTERY
TERMINAL
(a) Before performing electrical work, disconnect the
battery negative (-) terminal in order to prevent a
short in the system.
E110592E01 (b) When disconnecting and reconnecting the battery
cable, turn the ignition switch and lighting switches
off and loosen the terminal pletely. Perform
these operations without prying on the terminal.
2. EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs
according to the specifications of the vehicle. The
expressions listed in the table below are used in this
section.
Switch Type
Ignition Switch (position) Engine Switch (condition)
Expression
Ignition switch off LOCK Off
Ignition switch on (IG) ON On (IG)
Ignition switch on (ACC) ACC On (ACC)
Engine start
START Start
F053330E02
ME
ME–2 METER – METER / GAUGE SYSTEM
PARTS LOCATION
SKID CONTROL ECU
(ABS & TRACTION ACTUATOR ASSEMBLY)
SLIDING ROOF CONTROL ECU (*1)
ECM (2GR-FE)
FUEL SENDER GAUGE ASSEMBLY
ECM (2AZ-FE)
ENGINE ROOM R/B BINATION METER ASSEMBLY
ENGINE ROOM J/B
ME
- DOME FUSE
- ECU-ACC FUSE
*1: WITH SLIDING ROOF
E128053E01
METER – METER / GAUGE SYSTEM ME–3
FOR 4 SPOKE MODEL:
STEERING PAD SWITCH
CLOCK ASSEMBLY
NO. 3 J/B
- FRONT PASSENGER SEAT
BELT WARNING LIGHT
TURN SIGNAL CERTIFICATION ECU (*2)
FLASHER
TIRE PRESSURE
WARNING ECU (*3)
ME
DLC3 A/C CONTROL AMPLIFIER
NO. 4 J/B
INSTRUMENT PANEL J/B
*2: WITH SMART KEY SYSTEM
- MAIN BODY ECU
*3: WITH TIRE PRESSURE
WARNING SYSTEM
CENTER AIRBAG SENSOR ASSEMBLY
E128054E03
ME–4 METER – METER / GAUGE SYSTEM
2AZ-FE:
ENGINE COOLANT
TEMPERATURE SENSOR
ENGINE OIL PRESSURE
SWITCH
2GR-FE:
ENGINE COOLANT
TEMPERATURE SENSOR
ENGINE OIL PRESSURE
SWITCH
ME
E132655E01
METER – METER / GAUGE SYSTEM ME–5
SYSTEM DIAGRAM