文档介绍：使用说明书Model1056双通道智能分析仪目录快速启动指南··························································································2快速启动指南树形图········································································3快速参考指南树形图········································································4一、通用技术规格··················································································5①接触式电导率··············································································6②pH/ORP/ISE··················································································7二、安装··································································································8三、接线································································································13四、变送器的操作················································································,。,。同时,要求准确连接电源线和输出信号线。,才能给分析仪供电。,快速启动(QuickStart)画面就会出现。快速启动程序的使用非常简单。。“左”、“右”箭头键,可以左右移动光标或改变小数点的位置。使用“上”、“下”箭头键,可以上下移动光标或增加、减少数字。,保存组态设置;按EXIT键,退出且不保存变更设置。在快速启动过程中,按EXIT键也可以使显示器回到初始画面(选择语言)。(图A),完成仪器组态。,仪器出现主显示屏幕,此时输出为默认值。,请回到主菜单,选择程序“Program”,然后,按照快速参考指南的树形菜单结构图(图B),完成修改。,请在Program下选择ResetAnalyzer(分析仪复位)。2快速启动指南树形图3快速参考指南树形图4一、通用技术规格外壳:材质为聚碳酸脂,防护等级为NEMA4X/CSA4(IP65);尺寸:外形尺寸155×155×131毫米(××);仪表盘开孔尺寸1/2DIN标准,139×139毫米(×);进线孔规格:?;显示:单色LCD显示,显示分辨率128×96,背光照明,有效显示面积58×78毫米(×);环境温度和湿度:环境温度为0-50℃(32-122℉),相对湿度为5-95%RH(无冷凝);贮存温度:-20至60℃(-4至140℉);电源:选型代码-01:115/230±15%VAC,50/60Hz,功耗10瓦;选型代码-02:20-30VDC,功耗15瓦;选型代码-03:85-265VAC,-,通用电源,功耗15瓦;备注:选型代码-02和-03带4个可组态的继电器。危险区域认证:选型代码-01、20、21、22、24、25、26、30、31、32、34、35、36、38和ANClassI,Division2,GroupsA、B、C和DClassII,Division2,GroupsE、F和DClassIII,T4Tamb=50°CRFI(无线电干扰)/EMI(电磁干扰):符合EN-61326标准。LVD:符合EN-61010-1标准。报警:4个报警继电器可用于被测参数或者过程温度报警,而且还可以组态成仪器故障报警。每个继电器均为独立设置,都可以组态成内部定时器。备注:只