文档介绍：内蒙古科技大学毕业设计(毕业论文) I 摘要本设计题目为中间包小车,驱动形式采用了交流电动机驱动,转速可调,结构形式为门型。它的作用是支承、调整、运输、更换中间包。它的工艺要求是小车结构有利于浇铸、捞渣和烧氧等操作;能在浇铸过程中前后调节水口中心线位置,并且能自动升降,以便于中间包的装卸。主要运用在了连铸机浇铸平台上,将准备好的中间包从准备的位置运输到浇铸位置,利用纵、横向微调和升降机构,使中间包水口对中并插入到结晶器中进行浇铸。升降机构的驱动方式有两种:电动,液压传动。车上设有中间包称量装置,每台中间包都配备四个测力传感器,利用压力变化时引起磁性材料导磁率变化输出的电信号与压力(重量)成正比,以显示中间包内钢水的重量。选用测力传感器的容量取决于中间包满罐的总重。其主要参数:中间包小车的开进工作速度 2-20m/min ;升降机构用电动机驱动,丝杠螺母的结构,升降的高度为 470mm ,行走机构行程为 16400mm ,对中行程为 150mm ,最大承载能力为 50t 。本文包含了绪论、设计计算、结论三部分。绪论部分简述了中间包车的各个主要部分的特性、技术要求和中间包小车的问题与改进措施。设计计算部分主要对设计参数及强度的校核。结论部分主要是对整个设计过程进行的小结。关键词:交流电机驱动;电动提升;中间包车;门型;设计计算。内蒙古科技大学毕业设计(毕业论文) II Abstra ct This design titled tundish car, drive form using AC motor drives, speed adjustable, structured as door type. Its role is to support, adjustment, transport, replacement tundish 。 It is the technological requirements of the car structure is conducive to casting, slag and burn oxygen and other operations; Can be adjusted before and after the casting process outlet centerline, and can automatically lift, In order to facilitate loading and unloading of the tundish 。 Mainly used in the continuous casting machine casting platform, The tundish ready transportation from the preparation position to the casting position , The use of longitudinal, transverse fine-tuning and lifting mechanism, The tundish nozzle on and inserted into a crystallizer for casting 。 Lifting mechanism driven in two ways: electric, hydraulic 。 The car has a tundish weighing device, Each es with four intermediate force sensor , Changes caused by the pressure change in ic permeability of the output signal and the pressure (by weight) is proportional , To display the weight of molten steel in tundish 。 Optional load cell capacity depends tundish full tank total weight. The main parameters: the car drove into the tundish working speed 2-20m/min ; Motor driven lifting mechanism, screw nut structure. Lifting height of 470mm , Walking mechanism stroke 16400mm ; On the stroke of 150mm , Maximum load capacity of 50t 。 Th