文档介绍：HO AND LO PURIFIER MANUAL OPERATION INSTRUCTION A) STARTING 1. SET ALL V/VS TO REQUIRED SYSTEM. (FOLLOW SET UP INSTRUCTION) 2. START THE PURIFIER SUPPLY PUMP. 3. OPEN STEAM INLET AND OUTLET V/VS TO HEATER. 4. INCREASE THE TEMP CONTROLLER TO SPECIFIED TEMP. 5. CHECK THE GEAR CASE OIL LEVEL. 6. START THE SEPARATOR MOTOR. 7. ONCE PURIFIER ATTAINS WORKING SPEED, OPEN BOWL CLOSING WATER V/V SV2. 8. AFTER ~15 SECS INTERVAL OPEN SEALING WATER V/V SV3 . 9. OPEN A COVER ON WATER OUTLET PIPE TO CONFIRM THAT THE BOWL IS FILLED, AND THEN SHUT BACK THE COVER. CAUTION : THE WATER MIGHT SPLASH OUT! 10. SHUT THE SEALING WATER V/V SV3 . 11. OPEN BOWL OPENING WATER V/V SV1 FOR 5 SECS. (CONFIRM BY ‘ THUD ’ SOUND OF BOWL OPENING AND SPIKE AT AMMETER). 12. REPEAT STEPS 7- 10 13. OPEN OIL FEED TO THE SEPARATOR BY OPENING 3-WAY V/V SV4 (PUSH DOWN RED KNOB AND TURN 180 DEG CLOCKWISE). 14. AFTER ~ 30 SECS SHUT THE BOWL CLOSING WATER V/V SV2 . 15. ADJUST THE THROUGHPUT AND BACK PRESSURE ACCORDINGLY. B) SLUDGE DISCHARGE 1. OPEN BOWL CLOSING WATER V/V SV2 . 2. OPEN THE DISPLACEMENT WATER V/V SV3. 3. SHUT OIL FEED V/V BY OPERATING SV4 . 4. AFTER ~ 30 SECS, SHUT THE BOWL CLOSING AND DISPLACEMENT WATER V/VS SV2 AND SV3 . 5. OPEN THE BOWL OPENING WAT