文档介绍：IMPORTANT: Fill in pertinent information on page 2 for future reference. MODEL 4650 Service Manual MODEL 4650 Job Specification Sheet Printed in . ? JOB NO. __________________________________________________________ ? MODEL NO. _______________________________________________________ ? WATER TEST______________________________________________________ ? CAPACITY PER UNIT ____________MAX. ___________PER REGENERATION ? MINERAL TANK SIZE ____________________________ ? BRINE TANK SIZE & SALT SETTING PER REGENERATION: _________________________________________________________________ Page 2 CONTROL VALVE SPECIFICATIONS Type of Timer A) “L” B) 7 Day C) 12 Day Day/Time of Regeneration____________________________________ Drain Line Flow Control______________________________________ gpm Brine Re?ll Rate____________________________________________ gpm Injector Size_______________________________________________ Printed in . Page 3 MODEL 4650 Installation and Start-up Procedure The water softener should be installed with the inlet, outlet and drain connections made in accordance with manufacturer’s mendations and to meet applicable plumbing codes. MANUAL REGENERATION KNOB 24 GR, GEAR SKIPPER WHEEL (SHOWS EVERY OTHER DAY REGENERATION) RED POINTER TIME OF DAYARROW RED TIME SETBUTTON 1. Manually index the softener control into the service position and let water ?ow into the resin tank. When the water ?ow stops, open a softened water tap until all air is released from the lines, then close the tap. Note: the various regeneration positions may be dialed manually by turning the knob on the front of the control until the indicator shows that the softener is in the desired position. 2. Manually index the control to the back-wash position and allow water to ?ow at the drain for 3 or 4 minutes. 3. Remove back cover plate. 4. Make sure that the salt dosage is set as mended by the manufacturer. Manually index the control to the brine ?ll position and allow t