文档介绍：QUESTION 1
When you are logged into a switch, which prompt indicates that you are in privileged mode?
A. %
B. @
C. >
D. $
E. #
QUESTION 2
mand shows system hardware and software version information?
A. show configuration
B. show environment
C. show inventory
D. show platform
E. show version
QUESTION 3
Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An 802. 1Q
trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the
native VLAN is not will happen in this scenario?
A. giants frames could saturate the link.
B. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send untagged frames.
C. A native VLAN mismatch error message will appear.
D. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send tagged frames.
QUESTION 4
mand would correctly configure a serial port on a router with the last usable host address in the
?
A. Router(config-if)# ip address
B. Router(config-if)# ip address . Router(config-if)# ip address
D. Router(config-if)# ip address
E. Router(config-if)# ip address
F. Router(config-if)# ip address
QUESTION 5
work default gateway applying to a host by DHCP is . Which option is the valid IP
address of this host?
A.
B.
C.
D.
E.
QUESTION 6
Which two addresses can be assigned to a host with a mask of ? (Choose two.)
A.
B.
C.
D.
E.
QUESTION 7
work administrator has asked you to check the status of the workstation's IP stack by pinging the
loopback address. Which address would you ping to perform this task?A.
B.
C.
D.
QUESTION 8
Workstation A has be