文档介绍：QUESTION 151
Refer to the topology and router output shown in the exhibit. A technician is troubleshooting host
connectivity issues on the switches. The hosts in VLANs 10 and 15 on Sw11 are unable municate
with hosts in the same VLANs on Sw12. Hosts in the Admin VLAN are able municate. The port-to-
VLAN assignments are identical on the two switches. What could be the problem?
A. The Fa0/1 port is not operational on one of the switches.
B. The Link connecting the switches has not been configured as a trunk.
C. At lease one port needs to be configured in VLAN 1 for VLANs 10 and 15 to be able municate.
D. Port 0/1 needs to be configured as an access link on both switches.
E. A router is required for hosts on Sw11 in VLANs 10 and 15 municate with hosts in the same
VLAN on Sw12.
QUESTION 152
You have finished physically installing an access point on the ceiling at your office. At a minimum, which
paramenter must be configured on the access point in order to allow a wireless client to operate on it?
A. AES
B. PSK
C. SSID
D. TKIP
E. WEP
QUESTION 153
Refer to the exhibit. work administrator needs to add a new VLAN, named VLAN3, to work
shown. Unfortunately, there is not another interface on R1 to connect to the new VLAN3.
Which approach is the most cost effective solution for this problem
A. Purchase a new module and install it on R1
B. Replace R1 with a new router that has at least three interfaces.
C. Configure a second switch to support VLAN3 with a VLAN trunk between SW1 and the new switch.
D. Configure a single VLAN trunk between R1 and SW1 and configure subinterface on R1 interface for
each VLAN.
E. Connect another router to a serial interface of R1. Use a interface on the new router for
VLAN3
QUESTION 154
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with
RouterC
A. As numbers must be changed to match on all the routers.
B. Loopback interface must be configured so a DR is elec