文档介绍：QUESTION 201
Which two values are used by Spanning Tree Protocol to elect a root bridge? (Choose two.)
A. amount of RAM
B. bridge priority
C. IOS version
D. IP address
E. MAC address
F. speed of the links
QUESTION 202
Refer to the exhibit. Assume that the routing protocol referenced in each choice below is configured with its
default settings and the given routing protocol is running on all the routers. Which two conditional
statements accurately state the path that will be chosen works and for the
routing protocol mentioned? (Choose two.)
A. If OSPF is the routing protocol, the path will be from R1 to R3 to R4 to R5.
B. If OSPF is the routing protocol, the path will be from R1 to R2 to R5.
C. If OSPF is the routing protocol, the path will be from R1 to R5.
D. If RIPv2 is the routing protocol, the path will be from R1 to R3 to R4 to R5.
E. If RIPv2 is the routing protocol, the path will be from R1 to R5.
QUESTION 203
Refer to the exhibit. work administrator is adding two new hosts to SwitchA. Which three values could
be used for the configuration of these hosts? (Choose three.)
A. host A IP address:
B. host A IP address:
C. host A default gateway:
D. host B IP address:
E. host B default gateway:
F. host B IP address:
QUESTION 204
work administrator changes the configuration register to 0x2142 and reboots the router. What are two
results of making this change? (Choose two.)
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode.
C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored.
E. The configuration in flash memory will be booted.
QUESTION 205
Refer to the exhibit. works connected to router R2 have been summarized as a
route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.)
A.
B. 19