文档介绍：原创通过答辩毕业设计说明书论文 QQ 194535455 摘要本设计为点胶机设计—悬臂式结构,末端执行器是一个固定在 Z轴上的点胶头, X、Y、Z 三个方向上都是由步进电机带动滚珠丝杠,将电机轴的旋转运动转化成工作平台的直线运动,实现了点胶机在规定工作范围内各个点的点胶、涂胶工作。在PLC 控制下,该结构能按照程序自动在相应的点完成点胶、在一段距离内完成涂胶工作,也可由手动控制到达工作范围内的各个点以及完成回零工作。选用的步进电机用电脉冲信号进行控制,将电脉冲信号的个数和频率分别转化成为末端执行器的位移和移动速度。关键词:点胶机、悬臂式、步进电机、滚珠丝杠、 PLC 原创通过答辩毕业设计说明书论文 QQ 194535455 A BSTRACT This design for glue machine design-the cantilevered structure, end actuator isa fixed in the Z axis ata point on the rubber head, X, Y,Z three direction isby stepping motor drive the ball screw, will the motor shaft rotation movement into working platform linear motion, realize a little gum machine in the provisions within the scope of work of various points point glue, glue work. In the PLC control, this structure can be in accordance with the procedures in the corresponding points finish glue, ina distance work to finish glue, can also be made by manual control to work within the scope of the various points, plete back to zero. The selection of stepping motor power pulse signal control, the electrical impulses of the number and frequency signal into a respectively at the end of the implementation of the displacement and speed. Key words: Glue machine, cantilevered, step motor, the ball screw, PLC 原创通过答辩毕业设计说明书论文 QQ 194535455 目录 1 绪论---------------------------------------------------------------------------------------------------------- 1 国外研究现状及发展趋势-------------------------------------------------------- -------- -1 国内研究现状及发展趋势---------------------------------------------------------- -------1 2 设计方案------------------------------------------------------------------------------------- -------- ----- 3 机械部分--------------------------------------------------- ---------- ------------------------ - ---3 电气部分----------------------------------------------------------------------- ------- ----------- 3 控制部分---------------------------- - ------------------------------------- ---------- ------------- 3 传动部分-----------------------