文档介绍：word
word
1 / 21
word
Now remove the heater controls which again pull out with little force.
I found that along the top edge of the heater controls where two plastic lugs which clipped into the dashboard itself.
word
word
2 / 21
word
These didn’t require any force to remove and in all honesty you can just get your fingers behind the unit and push it out uniformly.
word
word
3 / 21
word
On either side of the unit were two spring loaded clips that just popped out in this process. (I should’ve photographed these!) I wouldn’t suggest pushing anything in from the sides of the unit as I have seen reference to on other guides, using a folded credit card etc. I had one of these to hand but it wasn’t necessary with this method. It may be that the pre-LCI cars have a different fitment. Slight pressure was all that was needed.
Once you have it out there are three multi plugs which simply unclip. The centre and right hand clips in the picture have a bracket which you unclip and hinge downward. It can be seen on the centre plug in grey against the black. You push this to the left of the picture and it releases the black clip.
word
word
4 / 21
word
Here with the unit removed you can see the hinge type clip in the background.
word
word
5 / 21
word
Once the heater controls are removed the outer plastic trim surround can be carefully pried off.
word
word
6 / 21
word
This is held in place by four long slim metal rods which again pull out with light pressure.
word
word
7 / 21
word
word
word
8 / 21
word
There is one multi plug which needs to be unclipped before freeing the surround pletely.
word
word
9 / 21
word
Next es the removal of the head unit
word
word
10 / 21
word
This is held in by four screws