1 / 20
文档名称:

山西高平科兴平泉煤业有限公司吊车设备采购及安装中标公示.doc

格式:doc   大小:2,690KB   页数:20页
下载后只包含 1 个 DOC 格式的文档,没有任何的图纸或源代码,查看文件列表

如果您已付费下载过本站文档,您可以点这里二次下载

分享

预览

山西高平科兴平泉煤业有限公司吊车设备采购及安装中标公示.doc

上传人:艾米 2022/1/6 文件大小:2.63 MB

下载得到文件列表

山西高平科兴平泉煤业有限公司吊车设备采购及安装中标公示.doc

相关文档

文档介绍

文档介绍:山西高平科兴平泉煤业有限公司吊车设备采购及安装中标公示
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
of rural drinking water sources, protection of drinking water sources in rural areas by the end of the delimitation of the scope of protection, complete with warning signs, isolating network protection facilities
吊装路线、吊车行进路线、吊车位置、地基处理等对照施工方案进行安全检查确认,确保其满足方案要求。  
2、吊装所用工器具齐全并就位,吊车、卷扬机等设备应有相应的检验合格证、出厂合格证或者大修检验合格证等合格证明,其技术性能必须符合安全质量要求,尤其是在使用300t、400t等大型吊车的时候更应该严格把关。在吊装前起重设备应进行试运转,发现转动不灵活、有磨损的应及时修理;钢构件在正式吊装前应进行试吊,经检查试吊情况,各部位正常并有各检查责任人签字确认后才可进行正式吊装。  
3、检查钢构件吊装的作业半径、吊车站位等平面布置参数,保证同施工方案一致。牵涉到多榀钢构件的吊装还应考虑到相应的吊装顺序。  
4、检查工作场地的准备情况,预埋件的完成情况及确认、混凝土的强度达到设计规定的要求、人员的安全防护措施、施工器具的准备完成情况等;施工作业区应设置安全警示标志,作业区与安全区区分明显,现场应严禁无关人员进入作业区。吊装施工时要设专人定点收听天气预报,当风速为10m/s时,有时吊装工作应该停止,当风速达到15m/s(6级以上)时,所有工作均须停止,并做好台风雷雨天气前后的防范检查工作。  
5、进场钢结构零部件、自拼部件、组件等应检查其相应的合格证、型号、规格、几何尺寸、焊缝检验报告等是否满足设计要求;钢构件堆放应避免金属构件的变形,并留有人员的通道与操作空间,避免二次运输,停放场地应留有足够的垫木。  
6、检查参加吊装人员的身体健康状况,确保每一个参加吊装人员身体健康状况合格。开始吊装前安排技术负责人及专