文档介绍：《木结构工程施工质量验收规范》GB50206-2012
《木结构工程施工质量验收规范》
GB50206-2012
广西建设工程质量安全监督总站
2013年11月表格修编
stator. Rotor installed in otection of stator plate rollover may occur). Dang wire rope close machine shell Shi, stop wear loaded and slowly Panasonic lane hooks put
目 录
木结构子分部工程质量验收记录.................................................................................................1 木结构子分部工程资料检查表.....................................................................................................2
方木和原木结构检验批质量验收记录 .........................................................................................3 方木和原木结构检验批质量验收记录(旧规范内容) ..............................................................7
胶合木结构检验批质量验收记录...............................................................................................13 轻型木结构检验批质量验收记录...............................................................................................18 木结构防护检验批质量验收记录...............................................................................................22
s thansurface with hard wood, or aluminum, lashing rope rotor with two points, the distance between two points is generally not lespole. Wire ropes lashing shall not damage the rotor surface using soft material wrapping wire rope, and the pad on the rotor lled end to end by a horizontal side arc slider and the slider lower sliding surfaces coated with a thin layer of grease. The rotor excitation traction insta-side back wheel below the shaft or parts installed steam-blades should be well marked. Rotor steamo blade removed, preventing scratches and flow fan blade diameter greater than retaining ring diameter of the rotor at the top, in front of the wear the stator, best t-e or nylon rope, tie outside the stator on the basis of, respectively. (Figure 20) axialur rophop in turn lower half of the hard steel sheet, rubber mat and curve skateboards on the plate fixed to the four corners of fond upper hangers supports or in the end cap oil parts installed spe