文档介绍：后退
936
KB
428
KB
KB
480
KE
flri
E □
殆1北£3
Jlink驱动文档位置，，驱动安装在默认目录下如下图:
:也址 C:\Proeran Files\SEGGER\Setup
Pl Xjik and J-Trace related sdFtwa「皀 p] Woriong with J-Luk: and J-Trace P2l 由前 downtoMi and fissh pr| Device speofics
F*| Targiec hterfices Md adapters 回占 20-Din JTAG/SWD CMPiesOr 巧 B4..1 Pinout fer JTAG
Pnout for SWD
it D1! Cl n Uii-br\r 1T and Tra^a
Pinout for JTAG
田
+
,3 Target power supply
Pinout for SWD
Power can be controlled via the J-Llnk commander. The following commands are available to contrOl power:
The following table lists rhe J-Link f ]-Trace SWD pinout.
Pin 15 of the eonnector can be used to supply power to the target hardware. Supply voltage is 5Vr max. current is 300mA. The output current is meinitored and protected against over load and short-drcuit.
The J-Llnk and J-Trace JTAG connector Is also compatible to ARMHs Serial Wire Debug tSWD)^
2 H«E
-G,m 曾 GND •帥4 K GN& 1}
GN" It SNO IS &N& 20 MD>
i"i
fl'i 土町 a El 3 E 3 £| 至 門 WarkFiQi wEfi
VTrarf teE Utfd Mt utt-d twfilCi 5WCU Y T mH 一 5,WD
RI^IT
Nfft BV-Sopply
About thE document Tabte oF Com tents Intrcductn 仃 IbcenEMig
Setup
J-Lrnk anS PTrace re faced
J-Unk and J-Trace
Flash download and 他曲 bre^Qhts Device卑电匚Ha
m 巴]Tar9et int电市匸邮 and adap>iefs -|Tj 2)0何i JJTAqfSWD Effinn&ctor 硏 Pfjflut fflf JTAG 曲 ^.|4 PfXkit
t 世目二斑阿 HiCtOf H*G