文档介绍：中文简历转英文简历
篇一：自己做的中英文简历
求职意向：
XX
.09-.01 北京科技大学控制工程专业研究生
.09-.06 北京科技大学自动化学士（专业排名：12%）
? Linux
.06ux Instruments: High Speed Oscilloscope (33GHz Bandwidth), BERTScope, Rumaster, SLTK, MCB, Temperature Chamber ?
?
?
?
? Debugged the parameters of TX CPRI link in the RUS board, after debugging, the signal sent out from SFP portat , , 5G, 10G rate satisfied the SFF 8431 TX standard. Sent out signal that satisfied the SFF 8431 TX stress eye standard from BERTScope to RUS board, debugged the RX parameters of RUS, made the signal sent to WARP at , 5G, 10G rate satisfied the SFF 8431 RX standard. Tested the BER of the signal, whose test pattern was PRBS7,at ,5 G, 10G rate with SLTK, and the BER was lower than 10-12. Tested the cold start (-40℃) and high temperature (WARP 105℃) performance of RUS board. Designed an 8 floors PCB named Kyocera 40K Inkjet Printhead Board by Altium Designer Winter a 672 pins FPGA,
the board was also integrated 2 pieces SDRAM, and I2C interface, LVDS interface, etc. Participated in all the design work such as the writing of analysis report, design of the SCH and PCB, the soldering and debugging, etc.
?
?
?
? Redesigned the FPGA program with Quartus II, completed thepower on, download and communication test. Soldered 10 pieces of empty printhead boards; Finished the arrangement of 1200 components in the lab and created an index. Based on Arduino, designed a board mainly about RS232 and Ethernet signalconvertingwith PADS . Designed a Relays Controller that controls two relays though 485 Bus. The signal transformer chip is MAX 485. .07-.03Beijing Founder Electronics Co., Ltd. Hardware Engineer Intern .01-.07 The First Research Institute of Ministry of Public Security of Engineer Intern
The robot known as ballbotwas driven by a basketball, used a Motion Processing Unit to detect the attitude, a STM32 as the controller, three step motors as the driver,