文档介绍：锐捷交换机基本配置(Ruijie switch configuration)
使进入特权模式
配置终端进入全局模式
粮农进入端口模式接口 / 1
出口退出端口模式
出口退出全局模式
锐捷交换机基础配置
2009-5-12来源：t-association 23
This interface is divided into VLAN3
S2724G (config) #int GI 0/20 - enter interface 20
S2724G (config-if), ftswitchport, mode, private-vlan, host
S2724G (config-if) ftswitchport private-vlan host-association 24
This interface is divided into VLAN4
Step five: complete the mapping of VLAN
S2724G (config) #int VLAN 2 - enter VLAN2's SVI interface
S2724G (config-if), #ip, address, 192. 168. 2. 1, 255. 255. 255. 0
-configure the IP address of the VLAN2
S2724G (config-if) #private-vlan mapping add 3~4
Add VLAN3 and VLAN4 to VLAN2
Notes：
, S20, S21 do not support private VLAN, you can achieve similar functions through protected ports
, S3250, S3750, and S5750 support both protected ports and private VLAN
S3760 does not support private VLAN and protected ports
port aggregation configuration
Question: how do you hook up the switch ports?
Answer：
S5750#conf
S5750 (config) ftinterface range gigab it Ethernet 0/1 - 4 - enter interface 1 to 4 at the same time
S5750 (config) ftinterface aggregateport 1 - enter aggregated port 1
Note: the interface configured for the AP interface will lose all previous attributes, and later operations on the interface can only be on the API port
Ruijie RGNOS CookBook
Nine
Conduct
spanning tree configuration
Question: how do you configure the spanning tree of the switch?
Answer：
Step 1: setting up the root bridge
Switch_A#conf t
Switch_A (config) #spanning-tree - the default mode is MSTP
Switch_A (config) #spanning-tree MST 10 priority 4096 - set to root bridge
Step two: non root bridge settings
SwitchBftconf t
Switch B
(config)
#spanning-tree - the default mode is MSTP
Switch_B (config)
#spanning-tree MST configuration
Switch_B (config)
#int fO/1 PC access port
Switch_B (config)
#spanning-tree bpduguard enable
Switch_B (config)
#spanning-tree portfast
port mirror c