文档介绍：控制器说明书(Controller specification)
The state of the controller
The ft-3 controller can make the controller in a differencond function key, press the display to display Eb:
Processing: the program that started the original interrupt processing (such as power off reset).
the function of each key under Eb status
The J/rotation: enter the entire graphics rotation Angle value (0 or less alpha 360 ° or less);
Remove/clear Angle: enter clear Angle (0 ~ 9999 mu m);
Online/symmetric: the input symmetry, once for the X axis symmetry, and the second symmetry for the Y-axis, three times.
Insert/rotation: input automatic rotation Angle value (0 or less alpha 360 ° or less);
Increment/circulation: the input cycle quantity (the number of the loop program is 0 ~ 99, and then the number of cycles will be 0 ~ 99 after this key).
End/total clearance: to clear all programs and parameters in the controller's memory:
Gy-/ cut: input negative compensation (minimum value - 9999 mu m);
GX / + : enter positive compensation (maximum 9999 mu m);
Zero/zero: fast back to the cutting point, the origin.
key functions under the state of n EA
0 9: input coordinates and count length values:
NR1 NR4: input inverse processing instruction;
SRI ~ SR4: input to the round processing instructions:
LI ~ L4: input line processing instruction;
X: shows the X value of program n.
Y: show the Y value of the NTH program;
Show J/rotation: display the J value of the NTH program;
Compensation/explicit Z: show the GZ nature of the NTH procedure (see appendix 2)
Delete/clear Angle: the n th bar is deleted continuously according to the second order, the original order n + 1 procedure becomes the NTH, and so on;
Online/symmetry: from the NTH bar to the program sent by the computer or telegraph machine:
Insert/rotate: a new procedure can be inserted at the second consecutive, the original NTH program becomes the n + 1 program, and so on;
Increments/loops: when viewing the program, press once, the p