文档介绍：附录1:
User Access Verification
Password:CISCO
1_R1>
1_R1>?
Exec commands:
<1-99> access-enable access-profile
cleastEthernet interfaces
2 Low-speed serial(sync/async) interfaces
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
126000K bytes of ATA CompactFlash (Read/Write)
License Info:
License UDI:
SN
Device# PID
Configuration register is 0x2102 1_R1#
附录5：
1_R1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z. 1_R1(config)#hostname x-a x-a(config)#exit x-a#
附录6：
x-a#show run
Building configuration...
Current configuration : 880 bytes !
! Last configuration change at 11:26:05 UTC Wed May 27 2015 !
version
service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption !
hostname x-a
!
boot-start-marker
boot-end-marker
!
enable secret 5 $1$phMv$woqxrP1p8HmPSAUJ/6Bop/
!
no aaa new-model ip source-route ip cef
multilink bundle-name authenticated
license udi pid CISCO2801 sn FGL151711V0
interface FastEthernet0/0 no ip address duplex auto speed auto
!
interface FastEthernet0/1
ip address duplex auto
speed auto
!
interface Serial0/1/0
no ip address no fair-queue
clock rate 125000
!
interface Serial0/1/1
no ip address clock rate 125000
!
ip forward-protocol nd
!
!
no ip http server control-plane
!
!
lin