文档介绍：装饰施工技术(Decoration construction technology)
Technical requirements for decoration engineering construction
Technical re of a plate to the four sides of the plate fixed, not multi-point simultaneous operation.
installation of other housing panels
installation of fiber, plywood, nail spacing is 80~150 mm, 25~35 mm long nails, nail should enter the surface 0. 5~1 mm, nailhole oily lacquer putty.
when installing the calcium plastic decorative board, the glue should be evenly distributed, and the fixed measures should be taken after being pasted, and the excess glue shall be squeezed out in time. Nail, nail spacing is greater than 150 mm, the nail should be flush, neat, and use the same color and surface coatings.
Two. Partition and wall decoration
Partition is divided into wooden keel partition and light steel keel partition. The size depends on the situation.
Installation of A. keel
, in the partition with the upper, lower and the base of the two sides of the joint, should be the width of the keel line, line requirements horizontal, vertical, accurate position. Along the top, along the ground keel, each after the handover of the keel should be kept straight.
, the keel should be fixed at the end, the fixed point spacing should be no more than Im, the fixed should be solid. Between the frame keel and the matrix, should install the seal strip according to the design request.
selection of the support card series keel, should be the first support card is installed in the opening of the vertical keel on the card, the distance is 400~600 mm from the keel at both ends of the distance is 20~25 mm.
, through the adoption of the series of keel, less than 3m partition installed one: 3~5m partition installed two: more than 5m installation three.
before installing the cover panel, check the stability of the partition frame. If it is not strong, the reinforcement shall be strengthened.
Installation of B. cowl panel
before installing the plasterboard, local reinforcemen