飞针测试输出--Probot手动输出.ppt

文档介绍：飞针测试输出
----Probot手动输出
输入Gerber数据. 数据要求:
1、信号(Signal layer);
2、钻孔文件(Drill files);
3、绿油层( Solder mask layers);
将钻孔层由“a01”改为“r01”,定义为钻孔,注意需要改变所有的孔层,包括盲、埋孔。(Change the Drill layer from “a01” to “r01”, it means it is DRILL. Change all drill layers, includes the blind drill or buried drill.)
检查孔层数据是否正确,如果不正确或没有孔径大小不正确,请重新读取孔层数据或手动修改孔层数据。
将顶层绿油层改为负片,即有“+”改为“-”;(Change the solder mask layer from “+” to “-”,Change the top solder mask.)
将底层绿油层改为负片,即有“+”改为“-”; (Change the solder mask layer from “+” to “-”,Change the bottom solder mask.)
进入到物理层设置,(Go to “Setup Physical Layer”.);
孔层仅仅需要是电镀孔(PTH),Only put the drill layer to the PTH;在设置物理层时,如果是埋、盲孔,必须设置将其与信号层一起设置与相应的物理层之中。(Since layer 2 is Blind drill, which connecting layer 3 & have bine it as 2&3, 2&4.)
來自大的资料库下载
注意

1、在物理层设置中,不需要任何的非电镀孔(NPTH);
We DON’T need to put the non-plated through hole (NPTH) in Setup Physical layer;
2、在飞针测试中。不需要任何的NPTH数据,你可以删除所有的NPTH;
You can just delete all the NPTH in GC-CAM.
3、在物理层设置中,绿油层不需要设置,仅仅需要孔层和信号层数据;
We DON’T need to put in the Solder Mask in Setup Physical layer.
We ONLY need all drill & signal layers.
将所有层都改为编辑状态“E”,
(Change all the layers to “E” status which means editable.);