文档介绍：龙口奇正汽车配件制造有限公司
LONGKOU QIZHENG AUTO PARTS CO., LTD.
全检操作指导卡
Fullinspectionoperation guidecard
T-3208-27-A
1、上盘：查看托盘e a record , qualified products pass to the next procedure.
4、中孔检测：首先检查领用的中孔塞规是否符合待检的型号，检查时将产品小外元一面向上平放在案板上，检查外安装面、外刹车面是否有缺陷；用中孔塞规检验通端通止为合格产品，通端止的需要修理，止端通的报废；使用粗糙度样块检验外安装面粗糙度，不合格产品做好记录摆放到不合格区，合格产品下传到下道工序。
Center hole inspection:First, check whether the center hole plug guage position in line with the pat number which should be inspected, put the product’s hat outside side up flat on worktable, check if there is defect in the mount surface, the brake face. Inspect with the center hole plug guage, with go side go is qualified, go side stop need to be repaired and no-go side go should bescrapped, usingroughness sample blockto testthe roughness of outside mountsurface. Defective products placed in unqualified area and make a record, qualified products pass to the next procedure.
5、大小厚度检测：检查时将产品立放在案板上，检查大外圆、小外圆是否有缺陷；用卡尺检验大小厚度；使用粗糙度样块检验制动面粗糙度。不合格产品记录后摆放到不合格区，合格产品下传到下道工序。
Size and thickness inspection: put the product on chopping board, check if there is defect in the brake outside and hat outside, use caliper to inspect size and thickness, useroughness sample blockto testthe roughness of mountsurface. Defective products placed in unqualified area and make a record, qualified products pass to the next procedure.
6、跳动检测：首先检查百分表、千分表是否完好，表架是否平稳，测量台是否完好，测量台垫盘是不是符合此