文档介绍：TRF018 — 2010 Test Report ( 测试报告) Dongguan New Shengda Lighting Co.,Ltd. ( 东进照明有限公司) ing test of electronic ballast ( 荧光灯用交流电子镇流器来料测试) Tested by( 测试人): Checked by( 审核人): Approved by( 批准): Edited by( 编制): Test report No.: Appliance ( 产品名称): Supplier.( 供应商): Sample description ( 样品描述): Date ( 日期): ERP No. or new sample ( 物料编码或新测试样品): Rating ( 额定参数): Test mothod ( 测试标准): IEC 61347-2-3:2000+A1:2004+A2:2006 Test purpose ( 测试目的): To check pliance of ing electronic ballasts ( 检查电子镇流器来料的符合性) Photos of test sample ( 测试样品照片) Act .(行为) Test description ( 测试描述) Result (结果) Remark (备注) □ Certificat e is valid or not (认证证书是否有效)□ Pass □ Fail □ 48h of endurance test (48 小时的老化测试)□ Pass □ Fail □ 100 times of ON/OFF test (100 次开关冲击测试)□ Pass □ Fail □ Abnormal condition (lamp doesn ’t start but the cathodes are intact) test ( 异常条件测试: 灯不启动, 但阴极完整)□ Pass □ Fail □ Abnormal condition ( rectifying effect ) test ( 异常条件测试: 整流效应)□ Pass □ Fail □ Pull test ( 防拉力测试)□ Pass □ Fail □ Electric strength test ( 电气强度测试)□ Pass □ Fail □ Output wattage test ( 输出功率测试)□ Pass □ Fail Result ( 结论): □ Pass ( 合格)□ Fail ( 不合格) Working temperature of ballast( 镇流器工作温度的测量) Test load( 测试负载): Test voltage ( 测试电压): Test duration( 测试持续时间): ta( 环境温度): T est Point (测量点) Measured (测量值) Max. L