文档介绍：2011届毕业设计(论文)
(2011届)
基于PLC的五层电梯控制设计
学院、系:
电子工程系
专业:
电气自动化
学生姓名:
班级:
电气091D
学号
指导教师名:
职称
2011年月日
摘要本次设计基于PLC的五层电梯控制系统的总体设计方案主要将可编程序控制器(PLC)应用到电梯的控制系统中去,以五层电梯为例来完成电梯PLC控制系统的总体设计方案、组成及程序设计。通过三菱FX2N可编程控制器,利用220V交流电源供压。在进行PLC的I/O接口分配,确定机内各种软继电器、通道代号,常用指令的编制规则。选用交流双速电机实现电梯拖动,采用楼层传感器实现楼层间翻转;显示驱动电路采用LED发光二极管。重点研究PLC的安全控制电路、楼层控制电路,开关门电路的设计,以及启动开关门程序、上行下行程序、楼层控制程序、自动定向程序的编写。PLC电梯控制系统只需要稍加改进即可应用于更高性能要求的电梯中。
关键词:PLC;电梯;曳引电动机;梯形图
Based on PLC, the five layers of elevator control design
Pick to: the design based on PLC, the five layers of elevator control system of the overall design scheme mainly will programmable logic controller (PLC) is applied to the elevator control system, with five elevator for example plete the elevator PLC control system of general design concept, composition and program design. Through the mitsubishi FX2N programmable controller, using 220V ac power supply pressure. In PLC I/O interface distribution, determine inside machine various soft relays, channel code, commonly used instructions pilation of the rules. Choose exchange double-speed motor realization of elevator drag, adopt floor sensor realize between floors reverses; Display driver circuit using LED light emitting diode. Key research PLC safety control circuit, floor control circuit, switch gate of design, and start to open closing procedures, uplink downline program, floor control procedures, automatic orientation program code. PLC elevator control system only need can be applied to improve slightly higher performance requirement
s of the lift.
Keywords: PLC, Elevator; Traction motor, Ladder diagram
第1章 绪论 6
6
7
设计要求 9
第2章交流双速电梯的基本工作原理 9
9
11
第3章输入/输出电路的设计 14
、抱闸电路、门锁及安全运行电路 14
16
16
第4章梯形图的设计 18
18
20
21
23
、消除和显示环节 25
、消除和显示环节 26
28
31
33