文档介绍：基于 DSP 的雷达信号参数估计的准实时处理方法研究
Abstract
The article presents an introduction of algorithm for signal parameter estimation
module in radar system. The algorithms of inra-pulse analysis and down-sampling are
discussed in detail, furthermore a series of optimization methods are used to improve
the efficiency of system on ADSP TS201S.
Inra-pulse analysis algorithm distinguishes signals and noises in time-domain by
the correlation character of signal and non-correlation character of noise. Then signals
can be easily sorted and parameters can be precisely estimated. In order to reduce the
calculation and improve the system efficiency, down-sampling method is brought out
based on the idea of intra-pulse analysis. This projest confirms down sampling rate on
the premise without spectrum aliaing first, then resolves sub-sampling signal’s pahse
ambiguity.
System’s real time is a very important problem in digital signal processing. Chapter
five focuses on how to increase processing rate in two aspects which are program design
and memory configuration, with the pratical example in project. When programming,
the algorithm should accord with the DSP internal hardware structure, such as using
both of the ALU; parallel statements should be more written to enhance the calculation
capacity in one cycle; pipline operation and pinline cost should be considered because
putation can be arranged between two statements while it is waiting result of
last operation. When memory allocating, buses need to be properly assigned to decrease
bus conflicts; datas that used at the same time should best put into different memory
blocks. After optimiziation, the result of the operation of this DSP system indicated that
the work is effective and coincide with the project requirements.

Key words :electronic reconnaissance, intra-pulse analysis, down-sampling,
quasi-real-time processing

ii
基于 DSP 的雷达信号参数估计的准实时处理方法研究

图表清单
图