文档介绍：摘要
本次设计主要任务是对解放牌汽车半轴端部三个孔进行的钻、扩、铰加工,以及四个工位的卧式组合机床的设计,主要完成是组合机床三图一卡和多轴箱的设计,另加一套随行夹具的设计,组合机床电气液压系统部分的控制。
组合机床是根据工件加工需要,由大量通用的部件为基础,配以少量的专用部件组成的一种高效专用机床。它的加工工序集中,它能够实现对一种零件进行多刀、多轴、多面、多工位的自动加工。在机床上可以进行钻孔、扩孔、铰孔以及倒角、切槽、攻螺纹、滚压孔等,也可以进行平面加工,包括铣平面、刮平面、端面等工序。其生产率高,加工精度稳定,研制周期短,便于设计,制造和使用维护,成本低等特点广泛应用在生产中。
本次设计除要对组合机床的机械本体部分进行设计,同时还对组合机床的液压系统和电气系统进行设计,根据指导老师的要求,在这里我采用PLC对机床进行控制。其中在说明书中具体写了卡具设计步骤以及夹紧力的计算,选用标准参数选取零件,在通过强度计算保证整个卡具在工作中的稳定性。
液压系统的设计主要是满足机床的动作要求来设计出的系统,我认真计算了液压系统的活塞总压力,计算了液压缸结构尺寸以及工作压力,油泵的工作的实际压力。对液压泵电机进行选择。
电气系统的设计就是运用机电传动的知识,即PLC系统进行控制,PLC控制系统我采用西门子系统实现的机床动作。
关键词:液压缸,液压滑台,液压站,弯曲成形,机电液
Abstract
This design primary mission is carries on to the liberation trademark automobile rear axle nose three holes drills, expands, the articulation processing, as well as four locations horizontal type aggregate machine-tools design, pletes is an aggregate machine-tool three charts card and the multi- axle-boxes design, adds separately a set to pany the jig the design, the aggregate machine-tool electricity hydraulic system partial controls.
The aggregate machine-tool is according to the work piece processing need, by the massive general parts is the foundation, matches one kind of highly effective special purpose machine poses by the few special-purpose parts. Its processing working procedure is centralized, it can realize to one kind ponents carries on the multi- knives, multiple spindle, the multi- surface, the multi-locations automatic processing. May carry on the drill hole on the engine bed, drill out, reams as well as the bevel edge, the grooving, the tapping, rollings the hole and so on, also may carry on the plane processing, including working procedure and so on mill plane, plane of surface scraping, end surface. Its productivity high, processing precision stable, the development cycle is short, is advantageous for the design, the manufacture and the use maintenance, the cost low status characteristic widespread application in the production.
This design except