文档介绍：Autodesk Inventor Tutorials
by Sean Dotson
sean@
Tips & Tricks
Latest Revision: 9/6/02
© 2002 Sean Dotson ()
Inventor is a registered trademark of Autodesk Inc.
By downloading this document you agreed to the following:
Your use of this material is for information purposes only. You agree not to distribute, publish,
transmit, modify, display or create derivative works from or exploit the contents of this document in
any way. Any other use, including the reproduction, modification, distribution, transmission,
republication, display, or performance, of the content on this site is strictly prohibited.
This section is intended to be a grab bag of tips and tracks for working with iParts. Many
of them e from readers like you who have found a neat way to e a
problem. Some are from Autodesk designers, some from me. Take the all with a grain of
salt, as I have not verified them all. Check back as the document will be updated from
time to time.
1. "Error" Messages
This es from Tom Sturtevant of Autodesk and concerns the "Active part does not
match the table values" message.
I think the point of that "error" is generally misunderstood - in
fact it's not an error, but an opportunity. Inventor assumes
that the factory will be in sync with the default row in the
table. It supports this in two ways:
1. When you edit the default row values in the table, the valu