文档介绍：沃尔沃公司标准 STD 7611, 131 部门/ 签发人: 6857 Anders Backman 第7版制定日期 1998-10 JB 页码 1(30) 制造规范电缆绝缘特性要求和试验编制原因目前还没有与本标准等同的国际标准或国家标准。本版本和第 6 版的区别如下: - 删除了第 节的注释“供应商不能使用再生材料制造绝缘材料”。-第 节“截面积为 平方毫米或 平方毫米的 50 米电缆颜色为红、蓝或白色”已经更改为“截面积为 平方毫米和 平方毫米的 50 米电缆颜色为红、蓝或白色”。-第 节“每种截面规格的 1 米电缆”已经更改为“每种截面规格的 10 米电缆”。- 更改了第 节中 AB Bandindustri 公司的电话和传真号码。-第6 节规定了强迫式通风。- 增加了图 2。- 删除了第 节中的绝缘层颜色表。- 修订了第 的要求。- 全面修订了短路试验。- 修订了表 5。- 删除了第 节中的注释“本试验仅适用于截面积大于等于 6 平方毫米的电缆”。- 删除了第 节 毫米直径备用磨损针。- 更换了 TVAB 电话和传真号码。- 明确指出了表 6 规定的循环次数适用于每个单项试验。- 循环次数适用于特定截面规格电缆的所有温度等级。- 修订了表 7。- 增加了水解试验。- 增加了环境要求。 MANUFACTURING SPECIFICATIONS Electric cables Insulated Property requirements and testing Orientation There is no international or national equivalent to this standard. This issue differs from issue 6 in that: - The note “ The supplier must not produce the insulation from regenerated material ” in section has been deleted - In section the text “ 50 m cable of cross- section area 0,35 mm 2 or 0,5 mm 2, colours red, blue or white ” has been changed to“ 50 m cable of cross- sectional area 0,35 mm 2 and 0,5 mm 2, colours red, blue or white ”- In section the text “1m cable of each cross- section area ” has been changed to“ 10 m of each cross-sectional area ”- In section AB Bandindustri ’s telephone and fax numbers have been changed - Forced ventilation has been defined in section 6 - Figure 2 has been added - In section the table of colours of insulation has been deleted - In section the requirement has been revised - The short-circuit test has been totally revised, - Table 5 has been revised, - The note “ This test is only applicable to cables with cross-section areas up to and including 6 mm 2” in section has been deleted - In section the alternative abrasion needle ofa diameter of 0,45 mm has been deleted - TVAB ’s telephone and fax numbers have been changed - It has been made clear that the numb