1 / 72
文档名称:

不同供电方式下等离子体脱除烟气中SO2及颗粒物的研究.pdf

格式:pdf   页数:72
下载后只包含 1 个 PDF 格式的文档,没有任何的图纸或源代码,查看文件列表

如果您已付费下载过本站文档,您可以点这里二次下载

分享

预览

不同供电方式下等离子体脱除烟气中SO2及颗粒物的研究.pdf

上传人:coconut 2014/6/6 文件大小:0 KB

下载得到文件列表

不同供电方式下等离子体脱除烟气中SO2及颗粒物的研究.pdf

文档介绍

文档介绍:华北电力大学(保定)
硕士学位论文
不同供电方式下等离子体脱除烟气中SO2及颗粒物的研究
姓名:史亚微
申请学位级别:硕士
专业:工学;环境工程
指导教师:原永涛;齐立强
2011-03
华北电力大学硕士学位论文
摘要
低硫高铝的准格尔煤是我国重要的动力用煤,这种煤燃烧后产生
的飞灰极难被电除尘器所收集,致使大量对人体有害的微细颗粒
直接排入大气。本文通过对电除尘器不同供电方式下氧化烟气
中 SO2 的反应动力学及其氧化产物 SO3 对微细颗粒物表面性能的影响
机理进行研究,并设计了窄脉冲电源。结果表明:传统供电方式下,
间歇脉冲控制方式脱硫效率最高,最高平均值电压控制方式次之,火花
跟踪和临界火花控制方式相当,其中间歇脉冲供电方式能耗最低,较最
高平均值供电方式节能约 261W;传统供电方式下,随着电场风速的减
小,SO2 初始浓度的降低,含湿量的增加,SO2 脱除效率相应的增加;
本文提出了晶闸管-Blumlein 型高压脉冲电源的设计方案,利用
PSpice 模拟了其理想负载下的电压波形图,得到了较理想的波形;通
过反应动力学分析,运用 MATLAB 对理想烟气条件下,O 2 、 H 2 O 浓
度,脉冲频率,SO2 初始浓度对脱硫的影响进行了数值计算,得出
H 2 O 浓度增大,脉冲频率提高,SO2 初始浓度减小有利于提高脱硫效
率;最后实验分析了脱硫产物 SO3 对粉尘比电阻、粒径、比表面积、
吸湿性、浸润性的影响,得到 SO3 能显著改善颗粒物的表面性质,使
之有利于收尘,因此该方法不但提高了除尘效率而且脱除了部分
SO2 ,实现脱硫除尘一体化。

关键词: 电除尘器;等离子体;脉冲电晕;SO2 ; ;烟气调质

I
华北电力大学硕士学位论文
Abstract
The Zhungeer coal that low-sulfur and high-alumina is an important
power coal, but the fly ash generated from Zhungeer bustion is
extremely difficult to be collected by electrostatic precipitators(ESPs),
resulting in a large number of harmful fine particles directly into
atmosphere. This thesis studies the ics of oxidation SO2 in flue gas by
plasma that excited by narrow pulse power and the influence mechanism of
oxidation products SO3 on the surface properties of fine particles. The
results show that: under the tradition power supplys, the intermittent pulse
discharge has the first desulfurization efficiency, secondly the highest
average voltage control, and thirdly the spark tracking and critical spark
control modes, in which the intermittent pulse has the lowest energy
consumption, it lower than the maximum energy that highest energy
consumption about 261W; The oxidation efficiency of SO2 increase with
the decrease of wind speed in ESPs, the reduction of initial concentration
of SO2 and the increase of moisture content in ESPs; We choose the
thyristor-Blumlein high voltage pulse power supply design scheme, and
simulate the voltage wa