文档介绍：A Handbook of English for Offshore Oil Drilling
海洋石油钻井常用英语手册
Drilling 钻井
Carry out drilling operation in accordance with the drilling program 按钻井程序进行钻井作业
Prepared bell nipple 准备”喇叭口”短节
Make up 2 joints of drill pipe 接两根钻杆
Break out this connection 卸开该接头
Run hole opener to sea bed 下扩眼器到海底
Mix gel fluid for drilling conductor hole 为钻导管井眼配制高粘度泥浆
Make up bottom hole assembly 组合下部钻具
Check and reset crown-saver on every tour 每个班都要检查并重新调整天车防碰装置
Number stands on trip out and trip in 起下钻时给立柱编号
Pick up BHA and run to seafloor 将下部钻具下到海底
Pick up stands 接立柱
Don’t drill faster than 15 minutes for 1 stand 钻进速度别超过15分钟1根立柱
Drop TOTCO 投(陶特)测斜仪
Fish TOTCO with overshot 用打捞筒捞起测斜仪
Resume drilling to TD 继续钻进到总深
Circulate 15 minutes循环15分钟
Run in hole 下钻
Put out of hole 起钻
Make an inventory of all ring gaskets 开一个所有垫圈的清单
Use spinning tong 使用气动扳手
Operate the air winch 操作气动绞车
Lay down 57 joints of 5” drill pipe 甩57根钻杆
Pick up drill stem test tool 提起钻杆测试工具
Circulate mud for 2 hours 循环泥浆2小时
Move string during circulation 在循环时注意活动钻具
Circulate hole clean 循环清洗井眼
Circulate bottoms up 循环泥浆几周
Fill up every 5 stands 每5柱灌泥浆一次
Check mud weight every 15 minutes 每15分钟检查泥浆比重
Reverse out excess cement 反循环替出多余的泥浆
Change/replace old mud by new mud 用新的泥浆替换出旧的泥浆
Stop drilling 停止钻进
Drilling ahead 钻进
Pull out of hole bit 起出钻头
Change bit 换钻头
Run the wear bushing 下抗磨补心
The bit thread type is regular pin 钻头丝扣是正规公扣
What’s the make-up torque? 上扣扭矩要多大?
Run in 9” collars 下9”钻铤
The cathead can’t give enough torque 猫头力量不够
Connect crossover sub 接上配合接头
The tong angle is too small 大钳的角度太小了
Stop circulating 停止循环泥浆
Break out the stand 卸立柱
Set the single into the mousehole 把这个单根放进鼠洞
Can we break out the pipe with rotary table? 可用转盘卸扣吗?
No! Break it out with tong 不行! 要用大钳卸扣
Spin it out with the air spanner 用气动扳手卸扣
Put the pipe wiper on the string 装上钻杆刮泥器
Don’t set this stand back 这根钻杆不要放在钻杆盒上
Make up the lift sub 接好提升短节