建伍TRC70.说明书.doc

文档介绍：TRC-70操作说明书
简明操作:
1) 设置频道参数,ENT一次,旋转大飞轮(搜索旋钮,最大的哪个旋钮)选择自己想要的频道号(如果频道内没有存数据就不显示具体的频率)。显示RX输入接收频率,前后不足的位数都用0补齐,MOD键选择调制模式,按ENT确认。显示TX,同样操作设置发射频率。
2) VFO模式:依次次按入C,8,4,ENT进入VFO,大飞轮或者键盘输入改变频率。按C,1,ENT飞轮改变100KHz,按C,2,ENT为1KHZ。按C,3,ENT变100HZ。按C,8,5,ENT回到频道模式。
3) 按键声音。C,8,0,ENT关闭按键声音。C,8,1,ENT开启。
4) 频偏控制:当进来的信号出现轻微的频偏时,调整此旋钮可以使接收频率清晰,频偏调整的范围是在当前显示频率(中心点)向两边以10HZ步长增加最大频率调整范围正负500HZ。显示★,信号清晰时ON(亮)。
5) C,7,0,ENT显示LCD所有的字符,可检查是否缺笔画
S301-1: OFF+
S301-2: OFFyL-v
S301-3: ON/p7G$
S301-4: ONi
Function 1 sets the rig to 100 Hz dial *Bev
Function 2 sets the rig to 1 kHz dial *k
Function 3 sets the rig to 100 kHz dial
Function 70 shows all the characters of the display, after entered the rig must be turned OFF and ON to reset the display back to
Function 80 turns ON the keypad’s entry confirm |NHLa
Function 81 turns OFF the keypad’s entry confirm |&
Function 82 turns ON the PTT confirm
Function 83 turns OFF the PTT confirm BEEP.}LJ
Function 84 sets the rig to VFO mode.|Tl
Function 85 sets the rig to MEMORY ;
NOTES:lO?4G
* By using the function 70 to visualize all the display’s characters, at the lower right corner you will see MED and LOW, this seems to indicate that the radio may be set to HI/LOW/MEDIUM output power, but I haven’t found how to do it, my guess is that there must be function to do it, some one suggeste