文档介绍:南昌工程学院毕业设计(论文)机械与电气工程学系(院)机械设计制造及其自动化 专业毕业设计(论文)题目车床液压系统设计学生姓名王印班级2007级学号 2007100594指导教师李志彪完成日期2011年6月10日2车床液压系统设计 Hydraulic System Design of the Lathe总计 毕业设计:页表 格:个插 图:幅I摘要 本 文是关于双头车床液压系统设计过程的阐述。主要包括系统方案的确定、液压集成 块与控制系统的设计几个方面的内容。双头车床加工时,由于零件较长,拟采用零件固 定,***旋转和进给的加工方式,其加工动作循环方式是:???进一工进-快退一停止, 同时要 求各个车削头能单独调整。显而易见,采用双头车床能使原需多道工序的产 品能一次切削完成,使工序简化,生产效益大大提高。且这种设计所产生的产品对成 均匀,精度高。对于双头车床的动力执行部分,本设计采用液压伺服机构。液压伺服 机构较其他机构有传动 平稳、噪音小、驱动力大等优点,同时也存在漏油、爬行、 体积大等缺点。为了尽量避免液压系统的上述缺点,系统设计时用集成块来代替管 路,在液压系统采用液压阀集成配置,可以显著减少管路联接和接头,降低系统的复 杂性,增强现场添加和更改回路的柔性,具有结构紧凑、安装维护方便、泄漏少、振 动小、利于实现典型液压系 统的集成化和标准化等优点。关键词:双头车床 液压 系统 液压伺服机构 II Abstract This text is a concerning of hydraulic system of the double-head lathe. In this text ,it primarily includes the determination of hydraulic system program, the design of the hydraulic manifold block and control system, and the design of the total layout of the contents. When we use the double-head lathe to work the components, because they are relatively long, we plan adopt the way of components fixing, cutting tool revolving and aheading. The circulate pattern of working movement is speeding-^-aheading^-withdrawing^-halting. Meanwhile, each turning head is required to adjust solely. Tell its own tale, it can made the produce needed several working procedure formerly cut completely only once , predigest the working procedure and improve the manufacture benefit enormously.