文档介绍：EXTRACT DOCUMENT HPM Cat No: Various Product Description: Specification Extracts for Insulated Plug Pins as per AS/NZS 3112:2000 Revision Note: Prepared by: Date: Approved by: Date: Project No: Page Drawing No: Rev. 935 1 of6 14980 A File: extract doc -insulated ? HPM Industries Insulated Pins All insulated pins manufactured for HPM shall be manufactured ply with HPM specification drawing 15777 “ Standard Insulated Pin ” The following specification extracts have been taken from Australian Standard AS/NZS 3112:2000 for information . Insulated pins manufactured in accordance with drawing 15777 will meet all requirements of this Standard, the following extracts are the relevant requirements referred to on the drawing. The critical test is the High Voltage Test (Clause ) and for Integral Pin Devices, the Tumbling Barrel Test (Clause ). Tests On The Insulation Material Of Insulated Pin Plugs General The material of the pin-insulation shall be resistant to the stresses to which it may be subjected at the high temperature likely to occur in conditions approaching the bad connection conditions and at low temperatures in particular conditions of service. Compliance shall be checked by the tests of Clauses to , below. Pressure Test At High Temperature A specimen of one insulated pin only shall b