文档介绍：This model paper was revised by the Standardization Office on December 10, 2020
EPS线条安装步骤
EPS线条安装步骤：
安装侧面 This model paper was revised by the Standardization Office on December 10, 2020
EPS线条安装步骤
EPS线条安装步骤：
安装侧面图：
第一步：将特制胶浆与特制水泥所调制的混合物按:1之比例配合，搅拌均匀后称为特制粘贴胶浆（或使用高分子益胶泥）。
The special mucilage and special cement mixture of the modulation by :1 the proportion coordination, stir called special paste mortar (or use the polymer cement)
第二步：清洁好安装基面，不可有任何杂质，在墙体预定上水泥钢钉（间距700mm左右）以防在安装过程中构架滑落。
Clean good installed base, do not have any impurity, in wall scheduled on cement steel nail (spacing 700 mm or so) in case in the installation process frame slide.
第三步：按实际需要的长度切割构建，切割完毕后，立即拼凑核对。在拼凑处，露出泡沫面的地方涂抹上粘贴胶浆或高分子益胶泥。迅速拼接好。
According to the actual needs of the length cutting construction, cutting, immediately upon the completion check together. In the piece together place, revealing the foam place daub paste mortar or polymer profit cement. Rapid together again.
第四步：将构件背面涂上粘贴胶浆，立即安装。利用水泥钉固定不动（2-4小时），轻推调整构件位置，确保校直所有衔接处，拼凑整齐。
Will the back member with paste mucilage, immediately