文档介绍：建筑设计规范(Architectural design specification)
It can be ignored after reaching a certain depth. PIO
Base: a load bearing r its combination of modulus. P36
1), when the wall length less than 1 m, in order to avoid cut too much affect the strength of masonry brick, brick should be in the design and construction of modulus is 125 mm module, such as 240 mm + (10) + 115 = 115, 365 = 365 + (10) + 240, + 490 + 490 = 115 + (10) + 115 (10), etc. Note:(
The inner dimensions are marked size. 2) when the length of the wall is more than Im, the influence of the brick modulus is no longer considered.
Wall foot: it is indoor ground below the foundation above this paragraph wall. The foot of the wall has inner wall and foot. P39
The horizontal moisture-proof layer of the wall: the anti-moisture of the wall is to lay a continuous horizontal moisture barrier in the inside and outside of the wall. P39 ' P41
(1) location of moisture proof layer:
When the indoor floor mat is concrete and compacted material, the inner and outer wall moisture-proof layer shall be within the cushion range, generally within 60mm of the indoor floor.
When the indoor floor MATS are permeable materials, the position of the horizontal moisture-proof layer should be on the indoor floor.
when indoor ground pad for the material of concrete, and the walls on both sides of the ground elevation difference or indoor floor below ground outside, should be in high and low two QiangJiaoChu moistureproof layer, respectively, set up a level, and set in the wall of the soil side vertical moistureproof layer.
(ii) moisture-proof layer practices:
Waterproof mortar moisture-proof layer: waterproof mortar is 1:2 cement mortar with a quality score of 3% ~ 5%, and the thickness is 20 ~ 25mm (not applicable to buildings with uneven settlement of foundation).
Linoleum moisture-proof layer: in the position of moisture-proof layer first, the cement mortar of 20mm cement slurry is applied to the horizontal layer, the upper bu