文档介绍:墙体剔槽施工技术交底(标准交底)
County continuation records has examined and approved the draft, spirit, believe, comprehensivxamined and approved the draft, spirit, believe, comprehensive Yearbook of zhuanglang already prepared draft, entered the phase of evaluation. Civil air defense work
County continuation records has examined and approved the draft, spirit, believe, comprehensive Yearbook of zhuanglang already prepared draft, entered the phase of evaluation. Civil air defense work
County continuation records has examined and approved the draft, spirit, believe, comprehensive Yearbook of zhuanglang already prepared draft, entered the phase of evaluation. Civil air defense work
鲁DQ-004
技术交底
0
0
3
工程名称
施工单位
有限公司
分项工程名称
墙体剔槽
交底日期
2013年 月 日
交底内容:
(2)、固定后,线管外壁与抹灰完成面间距不小于15mm。
(3)、线槽深度50mm以上的,采用豆石混凝土浇筑后,用1:。线槽深度每30~50mm分两次抹灰。
:
,应预先进行弯曲加工,管子弯曲也可以在管子切 断前进行。钢导管的弯曲,应将配管本身进行煨制。在弯曲时不但要掌握一定的技巧,在弯曲过程中还要注意,弯曲处不应有折皱、凹穴、和裂缝现象,弯曲程度不应大于管外径的10%,弯曲角度一般不宜小于90度。弯曲半径不应小于管外径的10倍。
,将弯管弹簧插入PVC管内需要煨弯处,两手抓牢煨弯处两端逐步煨出所需弯度,然后抽出弹簧。
:
:
钢管连接采用套管焊接,钢管内外做防腐处理,管口处平齐不歪斜,管口用刮刀铣光滑,扫管后无毛刺,管内铁屑处净,管道敷设时,尽量减少弯曲,当直角弯有三组且长度较长时,均应按规范在中途装设接线盒。
阻燃PVC管使用套管连接(包括端接头)。用小刷子粘配套共饮高的塑料管粘接剂均匀涂抹在管外壁上,将管子插入套管,管口应到位。粘接剂性能要求粘接后1min内不移动,粘性保持时间场,并具有防水性。
配管固定
,用铁丝将管子绑牢,管路垂直或水平敷设时,每隔1m距离应有一个固定点