文档介绍：美的Q^idea
GS标准生产注意事项
标识和说明书
器具的铭牌必须有额定电压、电压特性、额定功率或电流、商标或厂名厂址、型号、回（II 类器具符号）、IP号码（对于IPXO以外的器具）
Cjlidea
Fan Heater
Model: NTK15AT
Witage: 220-240V- 50Hz
Power Input: 1500W
Cjlidea
Fan Heater
Model: NTH20R
Voltage: 220-240V- 50Hz
Power Input: 2000W
I 金 feS @ 虽-
Dry-wet vacuum cleaner
Model: QZ10B
Witage: 220-240V- 50Hz
Power Input: 1000W
Degree of protection: IPX4
C €
器具内的关键电器件必须有正确的标识（额定电压、电压特性、额定功率或电流、商标或厂名厂址、型号）：
电源开关、倾倒开关、温控器、热熔断器、限温器、发热丝或发热管、内部导线、电源线和插头
各符号的标识或丝印：电源开关：用0表示关（OFF） I表示开（ON）或用指示灯，用不借助于背景知识就能明白的符号，如风档佢，低档
I,中档II和高档III。
禁止覆盖（DO NOT COVER）丝印在器具顶面（字体高度不小于3mm）,不适用于远红外电暖器、。
说明书警语：
对于 Y 型连扌妾：If the supply cord is damaged, it must be replaced by the manufacturer, its service age nt or similarly qualified persons in order to avoid a hazard.
禁止覆盖：WARNING: In order to avoid overheating, do not cover the heater.
不能放在插座正下方：The heater must not be located immediately below a socket-outlet. ：Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned in correctly.
对于可移动的电暖器：Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
对于油汀：This heater is filled with a precise quantity of special oil. Repairs requiring opening of oil-c ontainer are only to be made by the manufacturer or his service age nt who should be contacted if there is an oil leak. When scrapping the heater, following the regulations concerning the disposal of oil.
，应该能在1米远的地方看清开关的标识。对于固定式器具，在正常使用时应能看到商标、型号。
爬电距离、电气间隙和固体绝缘
基本绝缘：爬电距离不小于4. Omm,电气间隙不小于2. 5mm 附加绝缘：爬电距离不小于4. 0mm,电气间隙不小于2. 5rnrri 加强绝缘：爬电距离不小于8. 0mm,电气间隙不小于4. 0mm 功能性绝缘：爬电距离不小于3. 2mm, 固体绝缘：对于附加绝缘厚度应不小于1mm或由2层分别能承受1750V/100mA/ 对于加强绝缘厚度应不小于2mm或由3层且其任意2层分别能承受1750V/100mA/ 1mi n.
的固体材料
举例：
功能性绝缘：PTC的厚度、电源开关不同极性之间
基本绝缘：绕组和铁芯之间、
附加绝缘：内部导线和塑料外壳表面、可触及的金属表面、通孔栅格的外表面加强绝缘：塑料暖风机指示灯带电