文档介绍:Wiring Standards at UVI
T-568 and Telephone Color Codes
Telephone Cable
Phone cable generally contains two pairs of wires, for two phone lines. The first pair is green and red; the second is black and yellow. The way you remember this is that there are two holidays: Christmas and Halloween. (I apologize if this is a US-centric mnemonic. I encourage everyone around the world to celebrate Halloween.) This set of colors is standardized for stranded wires (where each "wire" consists of about 20 little tiny wires that stick in your fingers and hurt like hell if you aren't careful.) For solid wires, the colors defined below for are used; pair 1 is White/Blue+Blue, pair 2 is White/Orange+Orange.
RJ-11 Plug Wiring
This is the wiring for the plug side of an RJ-11 connector. Can you say "BRGY"? (Think about cheap red wine; I know I do.) The diagram is shown with the "hook" - the little thing you press on to get the plug out - underneath. RJ-11 sockets always have the colors indicated on the terminals.
Note that the connector on the other end of an RJ-11 connector is wired in reverse order. That is, if you stretch the cable out flat, the Black wire stays on the left all the way to the other end, including through the connector with the hook oriented down also. Also note that the RJ-11 connector has six terminals on it. Only the middle 4 are normally used. Line 1 is the center pair: red and green, as in Christmas.
T-568B Color Code for RJ-45 Plug
Eight-conductor data cable contains 4 pairs of wires. Each pair consists of a solid (or predominantly) colored wire and a white wire with a stripe of the same color. The pairs are twisted together. To maintain reliability on , you should not untwist them any more than necessary (like about 1 cm).
There are two wiring standards for these cables, called "T-568A" and T-568B" They differ only in connect