文档介绍：13. Installation is the reverse order of removal.
• Use a pry bar(A) being careful not to damage the differential and joint.
• Do not insert the pry bar(A) too deep, as this may cause damage to the oil seal.
• Do not pull the driveshaft by excessive force it may ponents inside the joint kit to dislodge
resulting in a torn boot or a damaged bearing.
• Plug the hole of the differential case with the oil seal cap to prevent contamination.
• Support the driveshaft properly.
• Replace the retainer ring whenever the driveshaft is removed from the differential case.
• Do not take the drive shaft a part. Please, replace drive shaft with assembly.
14. Check the alignment. (Refer to SSgroup 'Tires/Wheels - alingment')
Inspection
1. Check the driveshaft boots for damage and deterioration.
2. Check the ball joint for wear and damage.
3. Check the splines for wear and damage.
4. Check the dynamic damper for cracks, wear and position.
5. Check the driveshaft for cracks and wears.
Driveshaft and axle > Propeller Shaft Assembly > Propeller
Shaft > Components ponents Location
Components
1. Propeller shaft
2. Center bearing bracket
Driveshaft and axle > Propeller Shaft Assembly > Propeller
Shaft > Repair procedures
Inspection
Inspect Flexible Coupling
1. Check the front and rear flexible couplings for cracks or damage.
2. Inspect the flexible coupling centering the busing is damaged, replace the propeller shaft assembly.
Propeller Shaft Runout
1. Install a dial indicator with its needle on the center of front propeller shaft or rear propeller shaft.
2. Turn the propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.
Front Propeller Shaft Runout : (.)
Universal Joint Inspect
1. Check that the spider bearing rotates smoothly.
2. Check that there is no play in the spider bearing if necessary, replace the propeller shaft.
Re